Pride Mobility Victory ES10, Owner'S Manual

Page: 34 / 44

34 www.pridemobility.com Victory ES Series
FRAME
LOCK-UP
PIN
SAFETY
LATCH
V I I . D I S A S S E M B L Y A N D A S S E M B L Y
FRAME SEPARATION
1. Lower the tiller and tighten the tiller adjust-
ment knob.
2. Remove the frame lock-up pin. See figure 24.
3. Lift up on the seat post and pivot the rear sec-
tion backwards until the frame hooks are no
longer resting on the lower frame tube. See
figure 25.
4. Slowly separate the two sections of the
scooter. See figure 25.
NOTE: The pivoting tiller is equipped with a
mechanism that will lock the front wheels in
place when the tiller is completely lowered and
secured.
ASSEMBLY
1. Position the front and rear sections of your
scooter as shown in figure 25 .
2. Lift the front section as you align the frame
hooks of the front section with the lower
frame tube of the rear section. See figure 25.
3. Once the frame hooks are over the lower
frame tube, lower the front section com-
pletely. This will engage the frame lock-up.
4. Reinstall the frame lock-up pin.
WARNING! Ensure that the frame
lock-up pin is properly installed
and that the pin safety latch is
secured before driving the
scooter.
5. Raise the tiller and fully tighten the tiller
adjustment knob.
6. Reinstall the batteries to the battery wells.
7. Connect both battery harnesses. See figure 23.
8. Secure the battery tie-down strap.
9. Reconnect the front-to-rear harnesses.
10. Reinstall the battery shroud.
11. Reinstall the seat and rotate it into place.
WARNING! After assembly, make
absolutely certain the tiller lock
knob is in the unlocked position
before driving the scooter.
Figure 24. Frame Lock-up Pin
Figure 25. Frame Separation
FRAME HOOKS
LOWER FRAME TUBE