17
JAZZY 1121/REV C/SEPTEMBER 2002
WWW.PRIDEMOBILITY.COM
I V . A S S E M B L Y
SEAT INSTALLATION
The Universal Mounting System (UMS) consists of universal parts that may be used on any medium back or high back seat,
regardless of seat width or seat depth. The two main components are aluminum extrusions that can be mounted to any medium
back or high back seat. These extrusions attach to a pair of trapeze bars that are mounted to standard Versa Seat towers. The
ELRs/Swing-away footrest hangers used on the UMS enable installation of ELRs, Swing-aways or heavy-duty drop-in leg
rests.
To install the seat:
1. Set the trapeze bars to the desired height. To change the trapeze bar height, see V. “Comfort Adjustments.”
2. Remove the front extrusion clamp from the front extrusion. See figure 7.
3. Tilt the seat back, and slide the rear extrusion onto the rear trapeze bar.
4. Lower front extrusion onto the front trapeze bar and secure the seat with the front extrusion clamp.
5. Plug the controller cable(s) into the connector on the electronics tray. See figure 4.
6. Route the cable to ensure that the cable cannot be pinched in the seat hinge.
7. Secure the controller cable to the armrest receiver with one or more wire ties.
Figure 7. Unversal Mounting System