Pride Mobility Jazzy 1107, Owner'S Manual

Page: 25 / 55

Jazzy 1107 www.pridemobility.com 25
Figure 18. Seatback Angle Adjustment
Figure 17. Seat Position (Extrusion Location)
V . C O M F O R T A D J U S T M E N T S
Seat Position
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the position:
1. Unplug the controller from the power base.
2. Remove the seat from the power base.
3. Remove both extrusions from the bottom of the seat. See
figure 17.
4. Reposition the extrusions on a different set of mounting holes.
You must move both extrusions the same number of holes
either forward or backward. See figure 17.
5. Fasten the extrusions back onto the bottom of the seat.
6. Reinstall the seat.
7. Plug in the controller to the power base.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback,
you can adjust it to four (4) different angles: 90°, 102°,
105°, or 107°.
To adjust the seatback angle:
1. Remove the seatback angle adjusting screw from each
seat hinge. See figure 18.
2. Set the seatback at the desired angle.
3. Reinstall the seatback angle adjusting screw to each
seat hinge and tighten.
Reclining Seat
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release le-
ver. The lever is located on the right side of the seat base.
See figure 5.
To adjust the recline angle:
1. Push down on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Armrest Width Adjustment
You can change each armrest’s width independently of the
other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
ARMREST KNOB
JAM NUTS
ARMREST
ANGLE
ADJUSTING
SCREW
SEAT HINGE
SEATBACK
ANGLE
ADJUSTING
SCREW