Pride Mobility Colt Twin, Owner'S Manual

Page: 36 / 48

36
www.pridemobility.com Colt Twin
V I I . D I S A S S E M B L Y A N D A S S E M B L Y
DISASSEMBLY
You can disassemble the scooter into several pieces:
the seat, the front section, the rear section, the bat-
tery shroud (if equipped), the basket and the batter-
ies or battery boxes. See figure 20. No tools are
required to disassemble or assemble your scooter,
but keep in mind that the disassembled sections of
the scooter take up more floor space than the as-
sembled unit. Always disassemble or assemble your
scooter on a level, dry surface with sufficient room
for you to work and move around your scooter–about
5 feet (1.5 meters) in all directions. Remember that
some scooter components are heavy and you may
need assistance when lifting them.
WARNING! Do not lift beyond your
physical capability. Ask for
assistance when necessary while
disassembling or assembling your
scooter.
If the scooter is not equipped with battery boxes:
1. Remove the seat by lifting it straight up and off of
the scooter. If you encounter resistance when re-
moving the seat, disengage the seat rotation lever
and swivel the seat back and forth while lifting up
on the seat.
2. Gently pull the battery shroud up and off of the
scooter.
3. Disconnect the battery tie-down strap.
4. Unplug both battery harnesses by pulling each har-
ness straight up. See figure 21.
5. Remove the batteries from the battery wells.
Figure 20. Scooter Components
Figure 21. Harness Connections
FRONT SECTION
SEAT
REAR SECTION
BATTERY SHROUD
BATTERIES
BASKET
*BATTERY BOX CONFIGURATION NOT SHOWN.
BATTERY HARNESS CONNECTIONS
WARNING! Failure to unplug both battery harnesses prior to separating the front and rear
sections could result in permanent damage to the scooter.
If the scooter is equipped with battery boxes:
1. Remove the seat by lifting it straight up and off of the scooter. If you encounter resistance when removing the
seat, disengage the seat rotation lever and swivel the seat back and forth while lifting up on the seat.
2. Remove the left battery box, then the right battery box.
NOTE: Always remove the left battery box first.
BATTERY TIE-DOWN STRAP