Pride Mobility Colt Twin, Owner'S Manual

Page: 25 / 48

25
Colt Twin www.pridemobility.com
I V . B A T T E R I E S A N D C H A R G I N G
The off-board charger supplied with your scooter is equipped with a 115/230 voltage switch. Confirm that this
switch is in the proper position for your locality. If you are not sure what the voltage is in your country, contact
your local electricity provider before inserting the charger power lead plug into your electrical outlet. If the
setting is incorrect, the charger will not function properly. Slide the voltage switch to the appropriate position.
See figure 10.
The LED lights on the charger indicate different charger conditions at various times: charger power on, charging in
progress, charging complete. Refer to the label on the charger for a complete explanation of these indicators.
Figure 10. Charger On/Off and Voltage Switches Figure 10A. Off-Board Charger
I
O
PLUGS INTO THE OFF-BOARD
CHARGER PORT
PLUGS INTO ELECTRICAL
OUTLET
VOLTAGE SWITCH
OFF
ON
If the off-board charger port is located on the tiller:
1. Position the front of your scooter close to a standard electrical outlet.
2. Remove the key from the key switch.
3. Make sure that the manual freewheel lever is in the drive position.
4. Make sure that the charger’s on/off switch is in the OFF position. See figure 10.
5. Plug the 3-pin charger power lead into the off-board charger port. See figures 5 and 10A.
6. Extend the charger power lead and plug it into the electrical outlet.
7. Turn the charger on. We recommend that you charge the batteries for 8 to 14 hours.
8. When the batteries are fully charged, turn the charger off and unplug the charger power lead from the electrical
outlet and then from the off-board charger port.
If the off-board charger port is located on the battery box:
1. Position the rear of your scooter close to a standard electrical outlet.
2. Remove the key from the key switch.
3. Make sure that the manual freewheel lever is in the drive position.
4. Make sure that the charger’s on/off switch is in the OFF position. See figure 10.
5. Plug the 3-pin charger power lead into the off-board charger port on the right battery box. See figures 5A
and 10A.
6. Extend the charger power lead and plug it into the electrical outlet.
7. Turn the charger on. We recommend that you charge the batteries for 8 to 14 hours.
8. When the batteries are fully charged, turn the charger off and unplug the charger power lead from the electrical
outlet and then from the off-board charger port.