APPLICATIONS
TROUBLESHOOTING
9
The self-leveling cross line laser can be placed on the ground,
mounted on an iron work bench / door frame etc. for point marking and
simple alignment by sight, It is ideal for the following applications:
• Hanging pictures, photos, or artwork on walls
• Wallpapering and stencil work
• Framing doors and windows
• Installing electrical wiring and pipes
• Mounting wall fixtures, electrical outlets, switches and lighting
• Installing a drop ceiling
• Painting
• Installing cabinets
• Laying tile and flooring
MAINTENANCE
This laser measuring tool has been designed to be a
low-maintenance tool. However, in order to maintain its performance,
you must always follow these simple directions:
• Avoid exposing the tool to shock, continuous vibration or extreme hot or cold
environment.
• Always store the tool indoors.
• Always keep the tool free of dust and liquids. Use only a clean soft cloth for
cleaning. If necessary, slightly moisten the cloths with pure alcohol or a little water.
• Do not disassemble the laser measuring tool, this will expose the user to
hazardous radiation exposure.
• Do not attempt to change any part of the laser lens.
PROBLEM
The laser line projection
is weak
The laser line is hard to see
Laser line is not projected
Laser line flickers for alert.
Batteries are weak
The tool is out of the
rated operating range
No batteries installed
or batteries are depleted
The surface where the tool,
has been placed is uneven
or the tool is working under,
manual mode
Replace with new batteries
Move the tool closer to be
within the rated operating range
Install new batteries
Place the tool on flat, surface
levels /-4 degrees
CAUSE
SOLUTION
