5. REMOTE CONTROLLER (OPTIONAL)
14
Remote controllers are available as an optional extra
,
The water heater can be installed with up to
three remote controllers. Each remote controller has two functions which can adjust the set tempera-
ture and indicate the error code on the remote controller.
PRIORITY function: The remote controller which is switched on first has the PRIORITY function,
and can adjust the temperature freely. While the remaining controllers could not adjust the tempera-
ture, the remaining controllers only dispaly the oulet temperature. Until the first remote controller is
switched off, then the PRIORITY function will be released to other controllers.
●
Default setting temperature: At the initial power on, the setting temperature will be the same as the
value set on the DIP switch. After the initial use, the initial temperature will be recalled.
●
The remote controller is water resistant, however should not be positioned where it can be splashed
directly and there should be caulking between the surface of the wall and the controller.
●
The remote controller can be intalled in the bathroom with correct intallation.
●
The remote controller is able to adjust the output temperature setting in the range of 38ºC to 65ºC.
●
The emperature setting points are:
38ºC, 39ºC, 40ºC, 41ºC, 42ºC, 43ºC, 44ºC, 45ºC, 46ºC, 47ºC, 48ºC, 49ºC, 50ºC, 51ºC, 52ºC, 53ºC,
54ºC, 55ºC, 55ºC, 56ºC, 57ºC, 58ºC, 59ºC, 60ºC, 61ºC, 62ºC, 63ºC, 64ºC, 65ºC.
●
All models of water heater have self diagnostic function for safety and convenience when trouble
shooting. If there is a problem with the installation of the unit, it will display a numerical error code on
the remote controller (or the LED of the computer board will blink.)
●
a.Remote controller installing environmental conditions.
b.Remote controller output temperature setting.
ON/OFF
button
Reduce
temperature
button
Increase
temperature
button
