MG14 operating manual Rev 1.4
4
1. INTRODUCTION
Please read this manual carefully to ensure optimum operating conditions right from the start. This user
manual handbook contains important information about functionality, installation, start-up and operation of
the Vacuum Gauge controller MG14
1.1 INTENDED USE
The Ionization Multi Gauge controller MG14 is a versatile microprocessor controlled ionization gauge
controller for pressure measurements in the range 2x10
-12
through 1x10
3
mbar. The concept and design of
the controller allow for a reliable and complete integration in complex process control systems. The Multi
Gauge MG14 can handle two measuring systems simultaneously. An optional different interface may be
used for complete remote control of the device.
In the following, the Ionization Multi Gauge MG14
will be referred to as «MG 14».
1.2 LIABILITY AND WARRANTY
PREVAC Sp. z o.o. assumes no liability and the warranty becomes null and void if the end user or third
parties
-
Disregard the information in this document
-
Use the product in a non-conforming manner
-
Make any kind of alterations (modifications, repair work, etc.) to the product
-
Use the product with accessories not listed in the corresponding product documentation
We reserve the right to make technical changes without prior notice. The figures are non-committal.
1.3 COMPATYBILITY
The MG 14 is partially compatible with its predecessor MG13. In order to operate the MG 14 in one of the
MG14 modes, you have to change the configuration settings accordingly. See Chapter 4.2.4.8 -
Transmitter
selection for channel 2
,
1.4 SAFETY
1.4.1 Personnel Qualifications
All work described in this document may only be carried out by persons who have suitable technical training
and the necessary experience or who have been instructed by the end user of the product.