PRETUL ROTI-12PC, Manual

Page: 21 / 24

9
Troubleshooting
Maintenance
• Keep the air vents clean and free of obstructing debris to
guarantee an adequate motor cooling.
• Regularly inspect all the assembly screws. Double check
they are correctly tightened. In the event one screw is
loose, tighten immediately.
• Use a clean and soft cloth to clean the tool. Never use
alcohol or detergent. Disconnect the tool and remove the
battery before cleaning.
• Servicing the tool shall be carried out only in a
Authorized Service Center.
• Service and maintenance carried out by non - qualified
people may result dangerous and could cause personal
damage. It also makes the Warranty void.
Cleansing and care Service
The hammer drill
looses efficiency.
The trigger cannot be
pushed.
The trigger can be
pushed but the
hammer drill stops
operations .
The torque regulator
stops operation.
The battery leaks.
The battery is not
charging and the
charger light is not
on.
The hammer drill
gets hot after long
periods or work.
The battery gets hot
while operating.
The battery gets hot
while charging.
The charger gets hot
while charging.
• Charge the battery.
• Move the direction button into the rotate or reverse
position.
• Charge battery.
• Adjust the regulator into a torque that allows the
job. Try with the next torque level.
• Immediately clean the liquid from skin or clothing
using water and soap.
• Replace the battery immediately.
• Insert correctly the battery to the charger.
• Double-check the battery is correctly connected into
the power outlet.
• Allow the hammer drill to cool off for 5 minutes.
• Stop the drill around 5 minutes to allow the battery
to cool off.
Problem Solution
• Low battery.
• The direction rotation button is in the blocking
position.
• Uncharged battery.
• Regulator is adjusted into a inadequate torque.
• Small leaking can be present in extreme
temperatures or after heavy use. This is normal.
• Intense leaking or very evident shows a
damaged battery.
• The battery is wrongly fit into the charger.
• The charger is not correctly plugged into the
power outlet.
• This heating is normal. It absorbs the energy
from the motor cogs and the electricity
generated during the job.
• This heating is normal. The energy absorbed
from the battery makes this warning.
• This type of warming is normal. Results from
the chemical reactions happening.
• This type of warming is normal resulting from
tension regulation.
Cause
Environmental protection
Power tools and batteries should not be disposed off together with household trash. Please deliver this tool and the
batteries to its adequate recycling in the authorized disposal sites. Verify the nearest recycling center in your community.
ENGLISH