PRETUL 27199, Manual

Page: 6 / 24

Cable
Protection
Float
Switch
Suction
Base
Cable Switch
Lock
Transportation
Handle
Power
Cord
6
Parts
• The connection source shall come from
properly installed and tested grounded outlets. Power
from the power supply and fuse shall match the pump’s
technical data.
• The pump shall be connected through
an RCCB (residual current breaker) with short circuit
current design not lower to 30 mA
• Before connecting double check the
power supply matches the pump’s requirements.
• The pump shall be used only within the
rated voltage, potency and rotation speed (see the
manufacturer’s nameplate).
• Do not entangle, tighten or run-over
the power cable. Protect it from sharp edges, oil or heat.
• Do not use extension cables with a
lower gauge than the power cable gauge.
• In the event the power cable is
damaged, disconnect the pump from the power supply
immediately! Never run a pump if the power cable is
damaged.
• Disconnect the plug from the power
supply before removing the pump from the water
or when servicing.
• Disconnect the pump when not in use.
• Before connecting the pump to the
power supply double check the float switch is set in the
OFF position (see page 8, section Float Switch).
• Before disconnecting the pump, the
float switch shall be set in the OFF position.
• Do not install nor connect the pump if
there are people or animals in the liquids to be pumped.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
WARNING
WARNING
WARNING
CAUTION
WARNING
1-1/2” Discharge
Connection
1” Discharge
Connection
1” Discharge
Connection
1-1/4” Discharge
Connection
ENGLISH
Safety Warnings for
Submersible Pumps