PRETUL 27019, Manual

Page: 3 / 24

3
27019
3 A
8 gal/min
1/2 Hp
60 Hz
Peripheral Water Pump
3450 RPM
Power
Technical Data
Power Cord Grips used in this product: Type “Y”.
Tool Build Quality: Basic insulation
Thermal insulation on motor winding: Class F
Power Requirements
127 V
1 NPT
20 minutes’ work per 15 min rest. Maximum 6 hours’ daily.
20 AWG
Class I
IPX4
26 ft
104 °F
BOAP-1/2P3
ENGLISH
WARNING
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a Authorized Service Center.
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
Conductors
Work Cycle
Insulation
Grade IP
Maximum Water Temperature
Maximum Flow
Outlet and Inlet Diameter
Maximum Suction Depth
Frequency
Speed
Current
Code
Description
Voltage
R
Connection to the energy source shall be carried out by a
professional in electricity, following the diagram to the right.
Use a separate electric circuit for the pump. This circuit
shall not have conductors with a caliber lower than 12 AWG and shall be
protected with a 20 A time delay fuse. Before. connecting the motor to the
current line, double check the voltage is equal to the data in the motor
nameplate. If operated with a lower voltage, the motor will get damaged.
The energy cables are coded with the following colors:
Green and Yellow: Earth
Black: Neutral
White: Line
All the wiring, electric connections and ground connections in the system shall comply with
THE OFFICIAL
MEXICAN STANDARD NOM – 001 – SEDE - ELECTRIC INSTALLATION (USE)
or with the local codes and ordinances.
The user shall call a certified electrician. It is recommended to feed the pump with a circuit that includes a differential switch
with an assigned current not higher than 30 mA
CAUTION
CAUTION
CAUTION
WARNING
65.5 ft
Maximum value of manometric height