Learn Mode B-
Programming the Sockets on your
n-ABLER
Step 1
- Put your n-ABLER into Learn Mode B
Press the Speed Control button at the rear of the unit together
with the Red Button and keep them pressed for at least one
second. As the unit enters Learn Mode B you will hear a
'warbling beep' and the LED flashes red.
Step 2
- Press the button you would like the Left Socket to
function as
For example, if you want the Left Socket to function as Double
Click, press the green (double-click) button once.
Your
n-ABLER
emits a single beep to acknowledge your
selection.
Step 3
- Press the button you would like the Right Socket
to function as
For example, if you want the Right Socket to function as Speed
Control, press the red Speed Control button (at the rear of the
unit) once.
Your
n-ABLER
emits a 'warbling beep' to acknowledge your
selection and to indicate that you are leaving Learn Mode B.
Your personal settings are stored in your
n-ABLER's
memory
and will be retrieved each time the computer is powered up.
You can quit Learn Mode B at any stage by pressing the Speed
Control Button until a 'warbling beep' is heard and the LED
returns to a steady green colour. Any new settings you made
will not be saved.
If you make a mistake simply return to Learn Mode B by
beginning at Step 1 and repeat the procedure.
Your
n-ABLER
is supplied with the sockets pre-programmed as
Left Click and Right Click. The sockets can be re-programmed at
any time to access any of the buttons INCLUDING THE SPEED
CONTROL BUTTON using the following procedure:
n-ABLER (trackball) 2010 leaflet:n-ABLER leaflet 14/4/10 16:57 Page 2
