15. Do not use outdoors.
16. Do not use appliance for other than intended use.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY.
Important Cord Information
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit
into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug in any way.
A short detachable power supply cord is provided to reduce the risk of becoming entangled in or tripping over a longer cord.
DO NOT
USE WITH AN EXTENSION CORD.
Do not allow the cord to run underneath or around the unit. The magnetic cord may not detach
easily if the cord is positioned in this fashion.
Connect the power supply cord to a 120VAC electrical outlet only.
How to Attach Legs and Handles
Tools Required: #2 Phillips screwdriver
Parts Included: 4 legs, 2 handles
To Attach Legs to Base
1. Place the multi-cooker upside down on the table or counter.
2. Using the screwdriver, remove the screws from the four mounting projections
on the bottom of the multi-cooker and set aside. Use these screws to attach
the legs to the base.
3. Position one of the legs, rubber foot facing up, over one of the mounting
projections (Fig. A). Align the hole in the leg with the hole in the mounting
projection and fasten securely with the screw. The leg should not rock or
move if twisted.
NOTICE:
Continuing to tighten, once secure, can result in the stripping of screws or the cracking of legs.
4. Repeat step 3 for the other three legs. When properly assembled, the multi-cooker should sit level with no leg rock.
To Attach Handles to Base
1. Place the multi-cooker upside down on the table or counter.
2. Using the screwdriver, remove the screws from the tabs on each side of the base and set aside. Use these screws to attach the
handles to the base.
HINT:
When removing the screw under the plug guard, hold the screwdriver at a slight angle or use a short screwdriver or a screwdriver
with a long shank.
3. Slide one of the handles, with the screw hole facing up, onto the tab so the hole on the tab aligns with the hole on the handle (Fig. A).
Fasten securely with the screw. The handle should not wobble, but slight movement from side to side is normal.
NOTICE:
Continuing to tighten, once secure, can result in the stripping of screws or the cracking of handles.
4. Repeat step 2 for the other handle. When properly installed, the handles should be parallel with the table or counter.
How to Attach Basket Handle for Deep Frying and Blanching
NOTE:
When using the basket for deep frying and blanching foods, position the basket handle
outside
of the basket.
1. Slide the lock bar up on the handle
(Fig. B). Then squeeze the handle bars
together and fit them into the bracket
guides. The pegs should rest on the
bracket tabs below the bracket guides
(Fig. B).
2. After attaching the handle to the basket,
slide the lock bar down (Fig. C) to
the locked position to ensure against
accidental detachment of the handle
from the basket.
2
Leg
Mounting
projection
Screw
Rubber foot
Handle
Tab
Screw
hole
Fig. A
Plug guard
Fig. C
Fig. B
Lock bar
Bracket
guide
Peg
Lock bar
Bracket
tab