14. Attach the filled frying basket to the removable pot using the drain hooks. Position cover over basket so that the cover vents
are on the opposite side of the basket handle. Now start the timer by pressing the
Time Start/Cancel
button on the control panel
(Fig. G). The unit will beep once and the display will begin to count down. you will notice the second digits as well as the
minutes digits will now be displayed.
15. Lift up slightly on the basket handle to disengage the drain hooks. Then slowly lower the filled basket into the preheated
oil until the bottom of the basket rests on top of the heating element.
If frying french fries or other high moisture foods,
immediately remove cover after lowering basket into oil.
Note: For crisper foods, fry without the cover.
Warning: To prevent the risk of severe personal injury or property damage, use caution when cooking with
hot oil.
It is normal for steam to escape from the cover vents during frying. To prevent steam burns, keep hands and face
away from the vents.
16. When frying time has elapsed, the unit will start beeping. The timer will immediately begin to count up to show how much
time has elapsed since the timer sounded. Press the
Time Start/Cancel
button to stop the beeping and count-up time and reset
to zero.
17. Check that the food is golden brown. If additional cooking time is needed, set the timer for additional time.
18. once the food is golden brown, lift the basket and hook it onto the fryer rim to allow oil to drain from food.
19. empty the food onto absorbent paper. Season to taste.
20. If frying additional food, repeat steps 10C through 19. If red signal light is on, allow oil to reheat until red signal light goes
out and green light comes on.
21. When frying is completed, press the
Heat Start/Cancel
button and unplug cord from wall outlet and then from deep fryer.
Allow oil and fryer to cool completely before removing control assembly and before cleaning.
Questions and Answers
What does it mean when the words
UNPlUG
and
PUSH
alternately flash in the display panel and the unit keeps
beeping?
The deep fryer has been overheated. The deep fryer is equipped with a sensor which will alert you if the unit has overheated.
overheating occurs if the unit is heated without oil or with insufficient oil. older oil that has become thick may not conduct
heat well and may also cause the sensor to trip. When the sensor trips, the following will occur:
1. The deep fryer will beep continuously.
2. The words
UNPlUG
and
PUSH
will alternately flash in the display panel.
3. The red and green signal lights will flash.
4. The unit will stop heating.
Whenever the unit has overheated, you will need to reset the fryer for cooking.
To reseT The fryer:
1. Unplug the unit and allow the unit to cool.
2. Correct the cause of overheating; for example, make sure there is sufficient oil in the fryer, or if the oil is old, replace
the oil with fresh oil.
3. After the unit has cooled, use the tip of a pen or pencil and push the red PoWeR ReSeT BUTToN on the back of the
control unit (Fig. A2, page 2). The unit will not operate until it is reset.
4. Plug the unit back in and reset the temperature and heat up cycle as described in steps 7 thru 9 on page 4.
What if the letters “
err”
start flashing in the display panel and the unit keeps beeping?
This lets you know that the temperature sensing device has become damaged or is defective. The unit will be inoperable; you
should unplug the unit and contact our Consumer Service Department weekdays 8:00 AM to 4:30 PM (Central Time) at 1-800-
877-0441 or contact us at our website
www.GoPresto.com
.
5
