128-6187B
7 of 8
7
mode and toggle the Valet/Program/Manual Override Switch 3 times in order to adjust the Fourth programmable
feature. The system would respond with 1 Chirp and the LED would begin to flash 4 Flashes, pause and repeat.
This has told you that the system is ready for you to adjust the Fourth programmable feature, and that it is currently
programmed for Chirps ON. A single press of the lock button of the transmitter will cause the system to
produce 2 Chirps. This signifies that you have changed the programming to Chirps OFF. Please follow the
programming procedure carefully and refer to the list of the Programmable Features above when programming
the system.
To program these selectable features;
Action
System Response
LED Pattern
Turn ignition on
No response
Turn the valet switch on then off 3 times
1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off
Short chirp, then long chirp
First
Then On
1 chirp = passive arming
1 flash pause
Press transmitter Lock button to change
2 chirps = active arming
or
Second Turn the valet switch on the off
1 chirp = auto locks on
2 flash pause
Press transmitter Lock button to change
2 chirps = auto locks off
or
Third
Turn the valet switch on the off
1 chirp = auto unlock on
3 flash pause
Press transmitter Lock button to change
2 chirps = auto unlock off
or
Fourth
Turn the valet switch on the off
1 chirp = passive lock
4 flash pause
Press transmitter Lock button to change
2 chirps = active locks
or
Fifth
Turn the valet switch on the off
1 chirp = chirps on
5 flash pause
Press transmitter Lock button to change
2 chirps = chirps off
or
Turn ignition key off
Exit program mode
NOTE : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between
steps, or the programming will be terminated.
COMPLETING THE INSTALLATION:
After you have confirmed the operation of the system and tested any and all optional features of the system:
1. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be certain
that the chosen mounting location will not inhibit any of the controls of the vehicle.
2. Secure harness and tie all wiring up and away from all hot and moving parts that they may come in contact
with under the dash board or in the engine compartment areas.
CAUTION: Particularly avoid the area around the steering shaft and column, as wires can wrap around these
mechanisms and impair the safe operation of the vehicle.
3. Check the vehicle's wipers, lights, horn, etc... to insure proper operation.
4. Replace all panels that were removed during installation, and retest the system.
5. Explain the operation of the system and its various features to the end user if available, and place the Owner's
Manual on the dashboard for them to find and review.
