8
GB
Operating Instructions - Accu Grease Gun
DANGER
■
■
Never work with the device in the vicinity of open fire, gas or other
combustible fluids.
■
■
The device can build up a high pressure (up to 400 bar). Safety glasses and
safety shoes are required. Keep hands away from rubber hoses under high
pressure!
CAUTION
■
■
Avoid contact with other metals during greasing because of the risk of
accidental earthing.
■
■
Do not expose the device to rain or moisture (electric shock!).
■
■
Do not use the accu charger in humid / moist rooms.
■
■
Do not use the grease gun if it is damaged, if it was stored under the open
sky or if it was dipped into a liquid.
7. Commissioning and putting into operation
Check the grease gun and the accessories for completeness.
7.1 Filling the grease gun
There are various possibilities to fill the grease gun:
■
■
Filling with grease cartridge according to DIN 1284
■
■
Filling with grease gun filling device by means of an optionally available adaptor (12 670).
7.1.1 Filling with grease cartridge according to DIN 1284
Removal of an empty cartridge:
■
■
Completely throw out the plunger rod until it locks at the upper end of the reservoir tube.
■
■
Unscrew the grease gun head.
■
■
Slowly loosen the handle, than pull the grease cartridge upwards and remove it from the device.
Installing a new grease cartridge:
■
■
Remove the cap from the full grease cartridge and insert it into the grease gun tube.
■
■
Only then tear off the pull-off cap of the cartridge and screw the grease gun head down.
■
■
Actuate the latch while pulling the plunger rod. Then push the plunger rod back into the tube.
■
■
Deaerate the grease gun (refer to 7.2 - Making the grease gun ready for operation).
NOTE
■
■
Ensure cleanliness during installation and that the accessories are correctly
connected with the grease gun head.
■
■
Use appropriate sealants and adhesives (e. g. Teflon tape).
