12
The seat falls down
and/or the lid stays
up.
-
First check whether the seat fits the toilet pan. – see
www.pressalitseats.com and “What fits your toilet”
-
The distance from the wall/cistern must be no more
than 14 cm. The distance ahead must be at least
120 cm.
-
The seat must be 5-7 degrees further back than 90
degrees to lock into place when open.
-
The seat could be mounted on a crooked toilet pan.
Use the enclosed oblique washers to adjust the an-
gle of the seat. See quick guide.
The damper does not
work after the seat has
been removed and
remounted.
-
The QR pins are not engaged. Open and close
the seat/lid several times until both buttons have
snapped into place. (See seat when it has been
removed).
-
If necessary, remove the seat from the toilet. Use
the battery changing key with the handle facing
forward and place it in the left side of the tube. You
can now turn the Y leg forward towards yourself.
The leg should be in the horizontal position after
troubleshooting. Then attach the seat to the toi-
let again in the same position as it was taken off.
We recommend 15 degrees.
At what angle is the
seat detached?
Place the seat/lid horizontally on the toilet. Lift the
seat off at a 15 degree angle while pressing in the
QR buttons on the side. Refasten by pressing in
the QR buttons, pressing the seat down over the
console at a 15 degree angle, and open/close the
seat/lid a couple of times until the QR buttons pop
out.
Troubleshooting
