4
STEP 2 LEVELING THE TABLE & INSTALLING THE SLATE
2.1
Place the cabinet in the desired location in the room.
2.2
Level the cabinet to the floor, shimming under the legs.
2.3
Set the 3 slate pieces in place and pre drill the slate screw holes into the slate support with a
3/16" drill bit. Level the table and slate combination with a spirit level both lengthwise and
cross wise, shimming as necessary.
2.4
Fasten the slate to the slate support using the screws provided.
2.5
Fill the joints and install the bed cloth.
STEP 3 ASSEMBLING THE CUSHION RAILS & POCKETS
3.1
Remove the packaging from the cushion rails and apply the billiard fabric to the cushion rails.
Note: This step may have been completed before the table was delivered.
3.2
Lay out all the rails upside down and install the pockets using the bolts supplied. Keep the
rail/pocket joint as tight as possible
3.3 Having bolted the 6 rails together turn the rail and pocket assembly right side up and place on
the table.
Caution: Be very careful at this point to avoid cracking a rail.
STEP 4
4.1
Align the rail/pocket assembly and loosely bolt it to the slate surface using the bolts and dome
washers provided.
4.2
Align the rail/ pocket assembly to the slate and tighten the bolts by hand
. (No power tools
please!)
WARNING: Do not over tighten
!
4.3
See the ‘Helpful Hints’ for installing the rail/pocket assembly found in the pocket carton.
Should there be any problems please contact us at:
Presidential Billiards, L.P.
20221 Caroline Way
New Caney, TX 77357
Tel: 281-572-4522
866-728-2253
Revised:
2/2/2015
ADDISON AND BILTMORE ASSEMBLY HARDWARE
