3
ADDISON AND BILTMORE BILLIARD TABLE
INSTALLATION INSTUCTIONS
NOTE: THESE CABINETS CAN BE DISASSEMBLED FOR DIFFICULT INSTALLATIONS.
Tools required by the installer:
Socket wrench 1/2", 9/16”
End wrench 1/2", 9/16”
Phillips screwdriver, #2 & #3
Staple gun to apply felt
½” Drive flex T handle
9/16” Socket (1/2” drive)
3’ or 4’ Spirit level
Prior to installation of the table please check for damaged or missing parts. Call Presidential Billiards at
866-728-2253 if there is a problem. The hardware is packed in several different packets. Each packet
indicates a step number. This coincides with the steps in this installation instruction and will hopefully
reduce your time to verify what hardware is required where. It is suggested that you retain the bolts in
their respective packets for ease of installation.
STEP 1
ATTACHING THE LEGS TO THE MAIN CABINET
1.1
Turn the cabinet upside down on the floor.
1.2
Install the hanger bolts in the legs (2 per leg)
TIP:
Jam 2 nuts together on the machine screw end of the hanger bolt and seat to the proper
depth in the leg. A long handled wrench, such as the flex-T socket handle will make this easier.
Ideally, an electric impact wrench with a 9/16” socket could be used. You may choose to install
the hanger bolts in the warehouse before going out to install the table.
1.3
Place the 4 legs in position and loosely bolt in place with the nuts and washers provided in
packet # 1.
1.4
Having placed all these components in position, align them so that all joints close tightly.
Tighten the bolts ensuring that the joints remain closed.
1.5
Damage may result from over tightening of components.
1.6
Set the cabinet up on its legs.
1.7
Install the wood screws through the leg bracket holes into the legs and tighten. (Pre-drill with a
5/32” bit.)
Note
: Ignore this step if screws are not provided in the step 1 bolt packet.
CAUTION
!!
Due to the extreme
hardness of the Teak timber, it is
necessary to pre-drill for the installation
of screws in the legs. (3/16”Drill)
