PRESIDENT TEDDY II, Owner'S Manual, Page: 34 / 72

34
- Press
MODE
key (
6
) to select the mode (
AM
,
FM
or
FM UK
) used
with new emergency channel.
- Short press on
PTT
switch (
8
) to validate and store the new emer-
gency channel. A validation beep sounds.
Note:
Emergency setting is not allowed if the current emergency
channel is not the active channel.
F - FREQUENCY BAND SELECTION
See on page 35.
6) MODE ~ NB
MODE
(short press)
This key allows you to select the modulation mode ( AM or FM ).
Your modulation mode has to correspond to the one of your
correspondent. Corresponding mode is displayed on the LCD.
-
Amplitude Modulation / AM:
communication on a field with relief
and obstacles at middle distance (the most used).
-
Frequency Modulation / FM:
for nearby communications on a flat
open field.
In U configuration ONLY:
press
MODE
key (
6
) to alternate the fre-
quency band between ENG and CEPT . “UK” appears in the display
when the
ENG
band is selected.
“UK”
disappears from the display
when CEPT is selected (see table at page 64).
NB
(long press)
Long press the
NB
key (
6
)
to activate/deactivate this filter.
NOISE BLANKER : This filter allow the reduction of back ground
noise, and some reception interference.
“NB”
is displayed when
NB filter is active.
7) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes
the setting of the equipment into the dashboard easier.
See cabling diagram page 67.
8) PTT (Push To Talk)
Transmission key, press to transmit a message, is displayed and
release to listen to an incoming communication.
See
FUNCTIONS WITH PTT SWITCH
on page 35.
TOT (Time Out Timer)
If the transmission key is longer than 3 minutes,
and the active
channel start blinking, the transmission ends.
The time-out tone will sound until the PTT switch ( 8 ) is released.
9) CHANNEL SELECTOR: UP/DN knobs on the microphone
These keys allow increasing or decreasing a channel. A «beep»
sounds each time the channel changes if the KEY BEEP function
is activated. See §
KEY BEEP
page 35.
See also §
2
page 32.
A) DC-POWER TERMINAL (13.2 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8
Ω , Ø 3.5 mm)
D) OPTIONAL VOX MIKE (Ø 2.5 mm)
C) FUNCTIONS TURNING ON THE UNIT
5 more functions are available. Turn off the unit. Turn on the radio
while pressing one or two keys to set the function.
1) ROGER BEEP
(
s
key or UP knob)
The ROGER BEEP sounds when the
PTT
switch (
8
) of the microphone
is released in order to let your correspondent speak. Historically as
CB is a “simplex” communication mode, it is not possible to speak
and listen at the same time (as it is the case with a telephone).
Once the conversation was over, he said “Roger” in order to
prevent his correspondent that it was his turn to talk. The word
“Roger” has been replaced by a significant beep. That is where
the name “Roger beep” comes from.
English