22
How to proceed:
-
Switch off the transceiver
-
Turn on the power while pressing the
F
(
7
) key. The letter corre-
sponding to the configuration is blinking.
-
In order to change the configuration, use the
s
or
t
key (
3
).
-
When the configuration is selected, long press on the
F
(
7
) key.
The letter corresponding to the configuration is continuously
displayed. At this stage, confirm the selection by switching off
then switching on again the transceiver.
See tables on page 56 ~ 61
.
G) FUNCTION WITH PTT SWITCH
1) NOISE GATE
(
PTT
+
F
)
-
Press and hold the
PTT
switch (
14
).
-
Short press the
F
key (
7
) to activate (
On
) or deactivate (
OF
) the
NOISE GATE
. “
” is displayed when the function is active.
Noise Gate:
Prevents amplification of background noise. This
results in optimized signal levels.
H) CHARGING THE RANDY III
1) USING THE AC POWER SUPPLY
1.
Clip the
home charger
(
C7
) to the bottom of the unit in any side.
2.
Connect the
AC power supply
(
C6
) to the
home charger
(
C7
).
3.
Plug the
AC power supply
(
C6
) into a 220 V socket.
2) USING THE MOBILE CHARGE MODULE
1.
Clip the
mobile charge module
(
C8
) to the bottom of the unit in
any side.
2.
Plug the cigar lighter plug of the
mobile charge module
(
C8
) into
your vehicle.
-
The charge begins. appears on the display to indicate charging
mode and indicates the charging level.
-
disappears when the unit is fully charged.
3) CHANGING BATTERY PACK
The battery pack is pre-installed in the unit. If you need to replace
the battery pack :
English
