PRESIDENT RANDY FCC, Instruction Manual

Page: 21 / 60

21
-
The charge begins. appears on the display to indicate charging
mode and indicates the charging level.
- disappears when the unit is fully charged.
3) CHANGING THE BATTERY PACK
The battery pack is pre-installed in the unit. If you need to replace
the battery pack :
1. Unscrew the battery pack door ( E ). If necessary, remove the belt
clip
(
C5
) or the
microphone support
(
C4
) to reach the screw.
2. Disconnect and remove the old battery pack.
3. Connect the new battery pack.
4.
Screw then the
battery pack door
(
E
).
Note : The battery pack is provided uncharged, so you must
charge the battery pack before using it with the transceiver.
4) LOW BATTERY FEATURES
When the battery is uncharged the RX/TX
LED
(
16
) blinks yellow.
A continuous beep sounds in TX mode. blinks on the display.
H) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels : 40
- Modulation modes : AM
- Frequency ranges : from 26.965 MHz to 27.405 MHz
- Weather channels : 162,400 MHz to 162,550 MHz
- Antenna impedance : 50 ohms
- Power supply : 13.8 V (Mobile configuration)
7.4 V (Handheld configuration)
- Dimensions inches : 5.98 (H) x 2.62 (W) x 1.46 (D)
mm : 152 (H) x 66.5 (W) x 37 (D)
- Weight without antenna : 0.67 lb with battery pack
305 g with battery pack,
- Accessories supplied : See page 2
2) TRANSMISSION
- Frequency allowance : +/- 200 Hz
- Carrier power : 4 W
- Transmission interference : inferior to 4 nW (- 54 dBm)
- Audio response : 300 Hz to 3 KHz
- Emitted power in the
adjacent channel : inferior to 20 µW
English