9
CONGLOMKB .COM
Please contact customer .service@conglomkb .com or 1-877-333-0098 for further assistance .
Installation (continued)
TOPMOUNT INSTALLATION
CREATING THE TEMPLATE
CUTTING THE COUNTER
NOTE:
Topmount sinks are dropped into the counter from above. If you are
installing an undermount sink, please see “undermount installation”
on page 6.
- Place the sink (A) upside down on the counter . Center the
sink (A) on the counter so that it is parallel to the front
of the counter, ensuring that it will not interfere with the
inside structure of the cabinet or the counter . It must clear
the overhang of the counter and the front inside face of
the cabinet . Trace the outline of the sink (A) with a pencil .
-
Draw a new line (2) 3/8 in. (9.5 mm) inside the first line
(1) . This will be the cut line . As this sink is 31 .5 in . x 20 .5
in . (800 mm x 521 mm), the cut line should be 30 3/4 in . x
19 3/4 in . (781 mm x 501 mm) .
A
1
1
2
30 3/4 in
(781 mm)
19 3/4 in
(501 mm)
Corner radius:
1/2 in (12 .7 mm)
CAUTION:
Always wear safety goggles and gloves when
using power tools to prevent personal injury .
- Using an electric drill with a 1 in . (25 .4 mm) hole saw,
carefully drill four holes (3) inside the cut line .
- Use a saber-saw or jig-saw to cut along the cut line (2) .
Place a support underneath the cut-out portion of the
counter to prevent it from falling during cutting .
- Insert the sink (A) into the cut-out in the counter to test
the fit. Make adjustments to the cut-out, if necessary.
1
2
3
3
3
3
A
