PrepPal PPM-10, Owner'S/Operator'S Manual, Page: 5 / 18

5
Attaching the Agitator to the Mixer Shaft(Beater, Hook, Whip)
1. Rotate the bowl guard to the left so it rests in the open position. Excessive force used to open
and close the bowl guard may damage the spring lock and bowl guard micro switch, and will
void the warranty.
2. Slide the agitator slowly upwards onto the planetary shaft fitting the shaft pin through the slot
in the agitator .
3. Rotate the agitator clockwise to secure it onto the planetary shaft.
Attaching the Bowl to the Mixer
1. lower the bowl by pulling the bowl lift lever forward and down to its resting position.
2. lift the bowl by the bowl handles and
a)
slowly position the locking pin (located on the rear of the bowl) into the hole in the middle
rear of the cradle.
b) lower the bowl onto the pins located on either side of the bowl cradle.
3. Once the bowl is positioned on the cradle, secure the bowl by pulling each bowl clamp forward
until the bowl is locked tight.
Setting Speeding
Select the appropriate speed setting by lifting or lowering
the speed control lever. Three fixed speeds are available
for use: first (1), second (2), and third (3).
Speed setting by different type of food and ingredient as
following:
Gear Speed Product Type/ingredient
1 (low) Heavy: mixing pizza, bread, pasta and
donut dough’s, waffle/cake batter,
mashing potatoes
2 (medium) Medium: 2nd stage of mixing for donut
dough, etc.
3 (high) light: whipping cream, egg whites,
meringue
Please follow the capacity chart to choose agitator
and speed.
NOTE: AlWAYS STOP the mixer before
changing speeds!