14 |
P a g e
Place a ‘P’ Clip around the second to end hoop with the leg of the P towards the inside edge of the hoop and pointing
towards the end hoop. This ‘P’ Clip should be located 9 inches up from the ground. Bolt one end of a Corner Stabiliser
to this ‘P’ Clip but do not tighten
(Fig19)
.
Fig19
Place a ‘P’ Clip around the end hoop, again with the leg towards the inside edge and pointing towards the second
hoop. Bolt the Corner Stabiliser to this ‘P’ Clip but do not tighten.
Check the ‘P’ Clip on the second to end hoop is still located 9 inches up from ground level, if it has moved then simply
slide the clip up or down the hoop until back in position. Tighten this ‘P’ Clip and secure with a self drill screw making
sure the head of the screw does not protrude past the hoop.
Using a spirit level to check the end hoop for vertical, slide the ‘P’ Clip up or down the hoop until in the correct position.
Tighten and secure the ‘P’ Clip using a self drill screw making sure the head of the screw does not protrude past the
hoop
(Fig20)
.
The predrilled holes in the ‘P’ Clip may not be in a suitable location for the self-drill screw, but the screw will make its
own hole in a place suitably clear of the Polythene.
Fig20
Repeat this process at each corner of the Sheep House.
