Premier ED-4899, Instruction Manual

Page: 11 / 13

P-4
ATTENTION BEFORE USING
1. This machine is set with safety unit, when the handle does not fasten the cover or the cutter seat is
not fastened, the motor cannot turn, so as to ensure safety for the user.
2. When disassembling or assembling the juicer, press the upper of feed port of the cover with your
hand, then force the handle to slide in or out of cover slot.
3. When disassembling filter first remove the cover and pulp container , then turn the middle ring up to
30 degrees by holding juicing spout with your hand ,and take up , the filter will automatically leave the
rotor
4. In order to avoid damage, before using, first check power supply for compliance with rate voltage.
5. Clean all parts able to disassemble (refer to the section of “maintenance and cleaning”).
6. When assembling, please carefully read the diagram of “name and position of main components”.
7. Please carefully rend the “attention” before using.
JUICING
1. Before using, please confirm the button switch of the main machine in stop state, in this way, in case
assembly is not completed, starting the main machine can be avoided, so unnecessary damage for
persons or property avoided.
2. Before juicing, first confirm filter and rotor clutched in position, and no hard contact between filter
cutter and transparent cover. Put the transparent cover on. Put the handle into the cover slot, then
turn on the machine.
3. For using, assemble according to the diagram of “name and position of main components”. Turn on
power supply, press switch to let the machine run no-load foe 5sec. Put prepared vegetable or fruit
into feed port of the juicer .press with the pushing bar, evenly, hard and slowly, juice of the vegetable
or fruit can be found, original, fresh, good for health.
4. Note: when pressing food with the pushing bar, force shall be even or indirect, pressing force shall
not be more than 1kg, no too sudden force, otherwise, juicing effect will be reduced.
OPERATING TIME
This machine is designed with button switches of O speed ,I speed ,II speed (0 for stop ,I for weak
speed ,II for strong speed ) For juicing , select strong speed for operating time ,after operating for 1 min
stop for 1 min ,then use again ,After the above operation is performed for three times , stop for 15 min
,do not operate until the motor is cooled ,in this way ,service lift of this machine will be prolonged , the
machine will serve you more efficiently
ATTENTIONS
1. This machine is unavailable for the weakness, unresponsive or psychopathic person (including
children), unless under the direction or help from the person who have the responsibility for security.
Children should be overseen, so it can be testified that they are not playing with it.
2. Before using, put this machine on a stable and even table board, operate according to the above
methods
3. Before juicing, first confirm juicing net and rotor clutched in position, and no hard contact between
juicing net cutter and transparent cover. Put the transparent cover on, fasten tight the handle, then turn
on the machine
4. Before being used, the motor works in running –in phase, there may be slight peculiar smell and
spark, this is normal, after the motor works for some period, the above phenomenon will disappear