premierpet.com
3
How it Works
The Premier Pet
™
Rechargeable Bark Collar effectively deters barking when it is worn. It has 15 levels
of static correction and begins with low-level corrections. If excessive barking continues, the correction
intensity will increase with each successive bark until the barking stops. Once the dog has learned to
reduce the barking, the initial warning corrections are reduced. As a built-in safety feature, if your dog
barks 15 times or more within a 1 minute 20 second period, the bark collar will automatically shut off
for 3 minutes.
What’s Included
Fit the Collar
Important: The proper fit and placement of your collar is important for effective operation.
1. Start with the collar turned off and your dog standing comfortably,
not sitting.
2. Remove all other collars your dog may be wearing and place the
bark collar around his neck. Place the collar on your pet so that the
Premier Pet
™
logo is right side up and the collar is directly under your
dog’s chin. Center the contact points underneath your dog’s neck,
touching the skin.
NOTE: It is sometimes necessary to trim the hair
around the contact points to make sure that contact is consistent.
3. Check the tightness of the collar by inserting one finger between the
end of a contact point and your dog’s neck. The fit should be snug but
not constricting.
4. Allow your dog to wear the collar for several minutes, then recheck the fit. Check the fit again as your
dog becomes more comfortable with the collar.
Do not shave the pet’s neck as this may increase the risk of skin irritation. The collar should not be worn for more
than 12 hours out of every 24-hour period. Leaving the collar on too long could lead to skin irritation.
Charge the Collar
Excessive charging can shorten battery life. Only charge your collar when the batteries are low.
1. Plug in and fully charge the bark collar. The LED on the bark collar will be solid red when charging and
will turn off when the bark collar is fully charged.
2. When the bark collar is charged, replace the rubber cover. The mud plug covering the charging port
must be in place for the bark collar to be waterproof.
Turn the Collar On/Off
To Turn the Collar On
Press and hold the On/Off button, the LED will give one quick flash then flash once every 5 seconds
(every 3 seconds when the battery is low).
To Turn the Collar Off
Press and hold the On/Off button and then release. The bark collar turns off.
Quick Tip:
When you are not using the bark collar, you will want to turn it off. This will increase
the battery life.
USB Charging Cable
Bark Collar
Contact
Points
LED
On/Off
Button
Charging Port
USB Charging Cable
Remote
Training Collar
Test Light Tool Long Contact Points
