- 15 -
Final line up adjustments
Step 7
With the projector secured in the mount and power on and
signal supplied to the projector you can now proceed with the
final height, tilt, roll and yaw to optimize the projected image.
Re-check hardware for proper tightness
and security
Ceiling
Allen wrench
Height adjustable
screws
Wood stud
The height can be adjusted by slightly loosening the two 8mm
height adjustment screws and raising or lowering the projector.
Once the height is achieved tighten the two screws.
A
To adjust the tilt angle of the projector, slightly loosen the side
M8 screws and tilt to the desired angle to the screen and firmly
tighten the two M8 tilt adjustment screws.
B
If roll adjustment is needed to square the images on the
screen, slightly loosen the front and rear M8 screws and adjust
to the desired angle then firmly tighten the two M8 roll
adjustment screws.
C
Tilt adjusting
screws
(roll) adjusting
screws
A
B
Allen wrench
Allen wrench
C
Ceiling
Wood stud
Ceiling
Wood stud
