www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Page 11
PTDM1
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
4
5/16” Washer
5/16” X 3” LAG BOLT
X 4
X 4
Do not overtighten the mounting screws.
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
n
n
Insert a small straw or toothpick into the threaded
inserts found on the back of the flat panel.
n
o
Use a pencil to mark the depth of the threaded
insert on the small straw or toothpick.
n
p
Mark the straw or toothpick 1/8” above the depth of
the threaded insert, as shown in Figure 1.
n
q
Insert the small straw or toothpick into the remaining
threaded inserts to compare and verify their depth
using the straw or toothpick’s 1/8” allowance mark.
n
r
Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the 1/8”
allowance mark on the small straw or toothpick,
as shown in Figure 2 and Figure 3, do not use
this screw. The screw length must not bypass the
mark.
n
s
Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
Proceed to the “Universal Washer Installation”
section.
Selecting the Mounting Hardware
Installing the Mounting Bracket