PBC-UMS
Bracket Installation
NOTE:
The two-piece mounting kegs are designed to allow for the positioning of each leg around
projector air vents located on the base of the projector. Where applicable, each leg mount may
be shortened by removing the locking screw. This will allow for a better bracket fit, overall.
NOTE:
For easier installation, the mounting legs should be first mounted to the projector. Each leg
should then be adjusted so that they can mount to the Universal Mount (Figure 3).
1.
Locate the mounting points on the bottom of the projector and use the appropriate number of
mounting legs.
2.
Select the mounting hardware that the projector requires and loosely install the universal mount on
the projector.
Figure 3.
Bracket Installation
Two Piece Leg
One Piece Leg
M5 Allen
Wrench
Inverted
Projector
Leveling
Barrels
M6 x 12mm
Hex Head
Screw
M5 x 12mm
Hex Head
Screws
M4 x 12mm
Hex Head
Screws
Universal Mount
In the event that your projector should require M3 hardware, please follow these
instructions:
1. Thread the leveling barrel into the hole on the mounting arm.
2. Place the M3 flat washer into the leveling barrel hole.
3. Use the M3 x 16mm Phillips Head screws to attach the leveling barrel to the
projector.
Page 10
Installation Manual