Installation Guide
P2642T
Attaching the Flat Panel to the Wall Plate
Mounting Bracket Adjustment
www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
This section requires two people.
Do not release your flat panel until you are certain that top and bottom hooks of both mounting
brackets are securely seated on the upper and lower mounting rails of the wall panel.
1) Raise the flat panel past the top and bottom mounting rails on the wall panel.
2) Slide the flat panel down slowly, keeping it close to the wall.
3) Engage the top and bottom mounting brackets to the rails of the wall plate.
Proceed to the
“Mounting Bracket Adjustments”
section.
Cette section exige deux personnes.
Éviter de relâcher votre écran plat jusqu’à
ce que vous vous assuriez que les crochets
de haut et de bas de tous les deux supports de montage sont bien posés sur les rails
de montage hauts et bas de la sablière.
M6 x 35mm
Locking Screw
(1 per Bracket)
M6 x 30mm
Leveling Screw
(1 per Bracket)
If your flat panel is tilted too far to one side, the leveling screws will allow you to
compensate for this tilt by simply adjusting the screws with a screwdriver.
Caution!
It is possible to dislodge your flat panel while you level your flat panel.
Use extreme caution until you tighten the locking screws.
Attention!
C’est possible de retirer votre écran plat pendant son réglage. User d’une extrême
prudence jusqu’au moment du serrage des vis de blocage.
After you have finished leveling your flat panel, be sure to tighten the two (2) M6 x 35mm
locking screws.
Do not overtighten the locking screws.
Éviter de trop serrer les vis de blocage.
Leveling Screw Adjustment
Locking Screw Adjustment
1) Loosen both locking screws.
2) Adjust the tilt of your flat panel.
3) Tighten both locking screws.
Page 10