ECM-3763S
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 7
Selecting the Appropriate Mounting Hardware
Insert a small straw or toothpick into the threaded
inserts found on the bottom or top of the projector.
®
Use a pencil to mark the depth of the threaded
insert on the small straw or toothpick.
¯
Mark the straw or toothpick 1/8” above the depth of
the threaded insert, as shown in Figure 1.
°
Insert the small straw or toothpick into the remaining
threaded inserts to compare and verify their depth
using the straw or toothpick’s 1/8” allowance mark.
±
Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the 1/8”
allowance mark on the small straw or toothpick,
as shown in Figure 2 and Figure 3, do not use
this screw. The screw length must not bypass the
mark.
²
Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
±
Proceed to the
“Griplate™ Washer Installation”
section.
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
