ECM-3763Q
Page 12
Installation Instructions
Technical Specifi cations
All measurements are in inches(mm).
Tilt Positioning
Adjusting the Flat Panel Friction Tilt Angle
Place one hand at the center top edge of the
fl
at panel.
Place the other hand on the center bottom
edge of the
fl
at panel.
Using the upper hand, gently pull the top of
the
fl
at panel towards you while the
lower hand gently pushes the bottom of the
fl
at panel away from you.
If additional tilt friction is required, tighten the
lower nut and lower bolt only to increase the tilt
friction.
Adjusting the Flat Panel to the Original Position
Place one hand at the center top edge of the
fl
at
panel.
Place the other hand on the center bottom edge of
the
fl
at panel.
Using the upper hand, gently push the top of the
fl
at panel towards the wall while the lower hand
gently pulls the bottom of the
fl
at panel away from
the wall.
Lower Bolt
Lower Nut