CTM-MS1
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 9
Installing the Mounting Brackets (cont’d)
Flat Panel
Griplate
™
Washer
Nylon Spacer
Mounting Bracket
Mounting Point
Mounting Screw
Griplate™ Washer Installation
Premier Mounts’ Griplate™ washers are designed to accommodate M4, M5, M6
and M8 hole sizes required by flat panels.
Do not place excessive pressure on the back of the flat panel, as this may
damage the flat panel.
The Griplate™ washers must be installed between the head of the
mounting screw and the mounting bracket as shown.
The dimples on the Griplate™ washers must be oriented as follows:
●
The Griplate™ washers installed at the top of the flat panel must
have the points of the dimples facing away from the flat panel.
●
The Griplate™ washers installed at the bottom of the flat panel must
have the points of the dimples facing towards the flat panel.
Does the flat panel have:
●
Recessed mounting points?
●
Uneven mounting points?
●
A curved back?
●
Any obstruction near the mounting point?
If
Yes
, you must install nylon spacers.
Proceed to “Nylon Spacer Installation”
below.
If
No
, you do not need nylon spacers.
Proceed to “Attaching the Mounting
Brackets to the Flat Panel” on page 10.
Nylon Spacer Installation
Premier Mounts’ nylon spacers allow you to attach the mounting bracket to flat
panels which have recessed or uneven mounting points. Each nylon spacer will
add distance between the mounting bracket and the flat panel.
The nylon spacers must only be installed between the mounting bracket
and the flat panel.
The nylon spacers will fit M4, M5, M6 and M8 screw sizes.
M8
M6
M5
M4
Griplate™
Washer
Flat Panel
Mounting Point
Bracket
Top
Griplate™ Washer
Dimple Orientation
Bottom
Griplate™ Washer
Dimple Orientation
