CTM-MS1
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 11
Safety Knurl Knob Installation
The safety knurl knobs keep the flat panel from being accidently
dislodged from the CTM-MS1.
1)
Fully extend the flat panel away from the wall.
2)
Install and tighten a safety knurl knob at the top of one of the mounting
brackets.
3)
Repeat
for the other safety knurl knob.
Safety Knurl Knob
(1 per Bracket)
Panelock™ Installation
Panelock
™
Hook
Security Head
Wrench
M6 x 12mm
Security Head
Screw
Panelock
™
Hook
Security Head
Wrench
If you chose not to install the safety knurl knobs and instead chose to
use the Panelock
™
, skip this section and proceed to the Panelock
™
Installation section below.
The Panelock
™
is a theft deterrent device. It comes with security hardware
that requires a special tool that is used to install and remove the security
head screws.
If the safety knurl knobs were previously installed, they must be
removed prior to installing the Panelock™ hardware.
1)
Slide the Panelock™ onto the top mounting rail, placing the Panelock™ to
the outside edge of the flat panel bracket.
Be sure that the Panelock™ is facing in the same direction as shown in
the illustration to the right.
2) Insert and tighten one (1) M6 x 12mm screw to attach the Panelock™ to
the flat panel bracket.
Repeat and
to
attach the remaining Panelock™.
Proceed to “Tilt Adjustment” on Page 12.
