Installation Guide
BARCO XT -
www.premiermounts.com | North America 800.368.9700 | Interna1-714-632-7100
Page 5
PRE-INSTALLATION
1. Attach the Adjustment Bracket to every
mounting location (Horizontal Rail) prior to the
installation of the mount, as shown.
2. Loosely fasten the M6 x 35mm Socket Head
to the bracket. The tip of the screw should
NOT
touch the surface of the horizontal
bracket to allow adjustments at post
installation.
STANDARD MOUNTING PROCEDURE
SPECIAL MOUNTING PROCEDURE
1. If any pre-drilled hole or off-center hole were created before or during installation, remove/loosen the
screws shown in figure 1 to expose the mounting point.
2. Re-position the bracket to the respective hole and anchor using the 5/16” Hex Lag screw (shown in
sequential step). The socket head screw must be twist in to stabilize the Horizontal Rail if the flat head
screw is not used.
M5 Washer
M5 x 8mm
Comb Screw
M5 x 6mm
Flat Head
M6 x 35mm Socket Head
(post-leveling screw)
5/8”-11 x 1.5”
Bolt With Hole
Adjustment
Bracket
Horizontal Rail
Loosen
pre-drilled or
off-center hole
Figure 1
Figure 2
Tighten
Twist in to stabilize
the horizontal rail
0.19” diameter for
#8 or M5 self tapping
screw
(optional).
Secure using the flat
head screw if possible.
Hex Lag
Bolt
Note:
Use the Bolt With Hole bushing when using a drill to create a pilot hole for concrete applications.
Reinforce the mounting location by using a self-tapping screw as an alternative for the flat head screw
after anchoring the bracket (optional).