Red Wagon Spinner
assembly
instructions
A
B
Step 1
The Strut Assembly of your Red Wagon spinner is shipped in three sections. Open Velcro Tabs on the Red Wagon Body Sleeve and insert the Front Strut
Assembly and the Rear Strut Assembly into the Sleeve. Both the Front Frame and the Rear Frame should be inserted so that the Wheel Fitting is closer to
the edge of the wagon than the center. Please note that the Front Frame and the Rear Frame are identical and can be used interchangeably. Insert the
Center Hub into the Sleeve. (diagram A)
Step 2
Once the Front Strut Assembly, the Rear Strut Assembly, and the Center Hub are in place within the Body Sleeve, connect the Rear Strut Assembly to the
Center Hub. Then Connect the Front Strut Assembly to the Center Hub. (diagram B)
WindGarden
b y p r e m i e r d e s i g n s
w w w . p r e m i e r k i t e s . c o m
sku #26828
Completed Internal Strut Assembly.
Make sure all parts connect as shown.
Center
Hub
Body Sleeve
Front
Strut
Assembly
Rear
Strut
Assembly
Velcro
Wheel
Fitting
Wheel
Fitting
Rear Strut Assembly
will have to be
connected to
Center Strut Assemby
Front Strut Assembly
will have to be
connected to
Center Strut Assemby
Open
Body Sleeve
