P. 3
User Guide
EX-6204 SH
Idle Mode
This feature allows you to remove the key from the ignition and leave the vehicle running
for its pre-programmed run time while you are away from your vehicle. This feature is
handy if you need to stop for a quick delivery, or at a convenience store.
To enable the Idle Mode:
1.
Press and hold
LOCK
,
UNLOCK
or
START/STOP
on your transmitter while the engine is
running.
2.
The parking lights will come
ON
.
3.
Remove the key, exit the vehicle;
•
Press the
LOCK
button if you need to lock the doors while the engine is running.
Caution:
Do not leave children or pets unattended in a car running in Idle Mode.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after
the user leaves the vehicle: the unit will take over the vehicle and keep it running for 60
seconds (or until it is shut down by remote control), then shut down the engine.
Proceed as follows to set the system to Turbo Mode:
With the engine already running, press the
LOCK
button on the transmitter until the parking
lights come
ON
.
Remove the ignition key from the ignition switch.
The engine will go on running.
Exit the vehicle and close the door.
•
Press the
TRUNK
button to lock the doors; the engine will shut down after
60 seconds of Turbo Mode.
Valet Mode
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the
engine from being remote-started accidentally.
To put the system
into
Valet Mode:
1.
Turn the key to the
IGNITION ON (RUN)
position.
2.
Within 3 sec. press the Valet button and release it. The parking light will flash 3
times indicating the module is now in valet mode. The LED will turn
ON
solid. The
system is in Valet Mode.
To take the system
out of
Valet Mode:
1.
Turn the key to the
IGNITION ON (RUN)
position.
2.
Within 3 sec. press and release the valet button. The parking light will flash twice
indicating the module is now out of valet mode and the LED will turn
off
.
The Valet button can only be used if the ignition key is in the
IGNITION ON (RUN)
position.
Ignition Valet
This feature allows the user to set the module into Valet mode by using the Ignition
Switch instead of the Valet button.
To ENTER Valet Mode
