PARTS DESCRIPTION
ASSEMBLY INSTRUCTIONS
1.
Loosen and remove the four screws from bar A and bar B. Cross
the 2 bars as shown in Fig.1 and align the four holes with those on
the flange. Secure the flange to the bars with the four screws. Slide
the base cap down over the assembly.
CAUTION: NEVER REMOVE THE SET KNOB, WHICH HOLDS THE
FAN HEAD IN PLACE (See Fig.2)
2.
If necessary, slightly loosen the set knob by turning it counter
clockwise. Slide the fan head down over the inner pipe and tighten
the set knob. Make sure the set knob is tightly secured.
3.
Unscrew the plastic collar from the shaft end of the motor housing
by turning the collar counter-clockwise.
4.
Mount the rear grille to the motor housing, by matching the 2 holes
on the rear grille to the 2 round pins on the front of the motor
housing. Push in firmly until the 2 pins protrude through the 2
holes.
5.
Secure the rear grille to the motor housing with the plastic collar.
6.
Insert the blade onto the motor shaft, matching the slot on the back
of the blade with the shaft pin (Fig.2). Secure blade with blade cap,
turning counter-clockwise to tighten.
7.
Test blade operation by rotating it with your hand. There should be
no friction with the plastic collar. If blade does not rotate freely,
repeat Steps 4 to 7.
8.
Open all securing clips on the front grille and unscrew safety nut.
9.
Hook front grille onto back grille and rotate until safety nut holes
are aligned. Secure safety nut & bolt with screwdriver.
10. Close remaining safety clips firmly to hold grilles together.
OPERATING INSTRUCTIONS
1.
Place the fan on a safe flat surface.
2.
To adjust height, loosen the Height Adjustment Control Collar.
Adjust to the desired height and retighten.
3.
Control the direction of the airflow by firmly holding the stand in
one hand and pushing the fan grille back to tilt up or by pushing it
forward to tilt down.
4.
To make the fan oscillate, push down on the oscillating knob
located on the top of the motor housing. To stop the fan from
oscillating, pull up on the oscillating knob.
FIG. 2
5.
Plug into an electrical power socket and switch on.
6.
Choose the desired speed by pushing the speed control buttons
Button to LOW, MED or HIGH.
MAINTENANCE
1. Before cleaning turn the fan off and unplug from the power
supply.
2. To clean the fan use a soft cloth to wipe off any dust. If the fan
is very dirty use a damp cloth and wipe dry.
Do not use any
cleaning detergents, sprays or other chemicals, as they will
damage the fan.
3. Store the fan in the original packaging in a ventilated dry area.
4. The motor bearings are permanently sealed and do not
require additional lubrication.
SPECIFICATION
Power: 50W
Voltage: 230V ~ 50Hz
N.W: 3.60kg
G.W: 4.10kg
- 4 -
- 3 -
