C. PARTS DESCRIPTION
Switch Panel
D. PRE-OPERATING INSTRUCTIONS
1.
Carefully remover your heater from the box.
(please save the carton for off-season storage).
2.
Do not use without feet fitted.
When operating, the distance between the radiator and the wall and any other
objects must be at least 3 foot (0.9 m) from the front of the heater and keep them
at least 1 feet (0.3 m) away from the sides and rear
3.
Make sure the unit is in the off position before plugging the heater into the power
socket and unwind the power cord from the cord bracket.
5. Place the heater on firm level surface in the upright position.
6. Avoid overloading the circuit. Do not use other high wattage appliances in the
same power socket. Never use a multi-point adaptor in conjunction with this
appliance.
Caution:
Do not cover or use to dry clothes.
The surface of this heater is hot when in operation.
E. FEET ASSEMBLY INSTRUCTIONS
FIG
1
FIG
2
FIG
3
Do not operate the heater without the feet attached to the bottom of the
unit.
Parts: 2 feet, 4 fixing screws
1.
Place the convector on a flat level surface or table.
2.
Align the two holes on the feet with the pre-drilled holes on the unit (fig 1 &
2) and secure in place with of the fixed screws (fig 3).
F. WALL MOUNTING INSTRUCTIONS
If feet are already assembled, remove them before fitting the wall brackets.
The brackets must be securely fitted to the wall, which must be 10cm minimum
thickness and no other objects, such as curtains or cabinets should be above
the heater, once fitted.
Upper bracket
Holding Hole
Lower bracket
Holding Hole
Upper mounted bracket
Upper sliding bracket
Lower bracket
1. Drill two holes 470mm apart from each other for the upper brackets.
2. Insert two raw plugs into the two holes.
3.
Securely fix the two upper brackets into the wall using the two provided
screws.
POSITION PIN
POSITION HOLE
FIXED SCREW
