IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product for future reference. The product and it’s
mains lead should be inspected before use for signs of damage. Do not use if there are any signs of damage, and consult your
supplier for advice.
PRODUCT SAFETY
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without supervision.
• Do not use in close proximity to gas appliances
• Do not use unless correctly installed.
• Do not cover when in use.
• Do not place the mains lead beneath a carpet or rug.
• Do not use the appliance in locations where paint, petrol or other flammable liquids are used or stored.
• Do no insert any object into the appliance through the grilles. This may damage the appliance or result in overheating or
electric shock.
• Do not use this appliance in the immediate surroundings of a bath, a shower or a swimming pool.
• The appliance is fitted with an overload cut-out which will operate if the motor overheats or is stalled. If this happens, disconnect
from the mains supply immediately, and allow the motor to cool down.
ASSEMBLY
1. Loosen the guard mount nut (4) from the motor housing (7)
2. Attach the rear grille (5) to the motor housing (7)
3. Secure the rear guard by attaching the guard mount nut (4) and turning tightly clockwise
4. Attach the fan blade (3) to the motor shaft (6) and fasten tightly
5. Place the front grille (1) on the rear grille (5) and secure using the clips attached to the front grille (1)
1. Front Grille
2. Blade Nut
3. Fan Blade
4. Guard Mount Nut
5. Rear Grille
6. Motot Shaft
7. Motor Housing
8. Fan Body
9. Control Panel
10. Mounting Plate
IDENTIFICATION OF PARTS
2
• Before installation select a suitable location for the fan where it is unlikely to
cause an obstruction.
• Draw a vertical centre line approx. 80 mm long on the wall
• Draw 2 horizontal lines 20 mm apart to mark the upper and lower screw holes for
the bracket.
• On the upper line mark 2 holes 11 mm either side of the centre line.
• Drill holes on the marked points using a 6 mm (¼”) masonry bit, and insert a wall-
plug.
• Fix the bracket to the wall and fully tighten all screws.
• Slide the fan onto the bracket.
WALL MOUNTING
