Prem-I-Air EH1524, User And Installation Manual

Page: 5 / 16

Page 5
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least
once every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is mandatory
for new buildings)
OPERATION
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead is rated at 13 Amps,
and that it is fully unwound.
Switch the unit on at the mains socket, and at the switch on the side of the
heater.
Make sure that the switch in the centre of the timer is in the correct
position.
Do not touch the air output grille when the heater is in operation, because it will
be hot and may cause burns.
Unplug the heater from the mains when not in use.
USING THE TIMER
When the timer switch is in this position, the
heater will be permanently OFF.
Use this
position in the summer when a permanently
installed heater is not required.
When the timer switch is in this position, the
heater will be controlled by the timer.
When the timer switch is in this position, the
heater will permanently ON.
The numbers around the timer dial show the time in 24-hour clock.The timer is
controlled by the plastic segments - each segment represents 15 minutes. Move
the segment outwards if the heater should be ON for that time period, or inwards
towards the centre of the dial if it should be OFF.