Predator H25S, Instructions For Use Manual

Page: 12 / 27

4
OPERATION
• Place the device on a flat level surface and ensure that the air intake and air outlet are clear of
obstruction.
• Insert the plug into a 230V-50Hz power outlet
• Move the ON/OFF SWITCH at the rear of the unit to the on
( I ) position.
• Press the button on the control panel to turn the heater on.
• Adjust the work mode, press
H25S has 2 working modes:
- L mode (1.200 W). Pilot L will remain lit in red.
- H mode (1.500 W). Pilot H will remain lit in red.
• Press button to turn on/off oscillation.
• Press button to set up the timer hours as below:
- 1 press,1hour, lamp 1
- 2 presses, 2 hours, lamp 2 on
- 3 presses, 3 hours, lamp 3 on
- 4 presses, 4 hours, lamp 1 and lamp 3 on
- 5 presses, 5 hours, lamp 2 and lamp 3 on
- 6 presses, 6 hours, lamp1, 2 and lamp 3 on.
• Move the ON/OFF SWITCH at the rear of the unit to the off position (O). Turn the power off and
disconnect the plug from the power outlet when not in use.
CLEANING AND MAINTENANCE
• If you do not use the device for a long time, clean it and put it in a box. Store in a dry, ventilated
place.
• To clean the appliance, wait until it is completely cold and disconnect it from the mains socket.
• Use a damp cloth to clean the unit. Never clean it by splashing it with water or inserting it into the
appliance.
• Never clean the appliance with acids, gasoline, benzene...
• Before using the appliance again, check it and make sure that nothing obstructs the air inlets and
outlets.