33
Step 78 Carbon Tail Support Struts - Gas SE
Insert and mark the position where the machined end fit
-
tings overlap the ends of carbon struts. Remove and sand
through the glossy surface up to the marked position and
ensure that the fittings will easily slide over the tubes. Sand
or score the inside surface of the end fittings. Mix up JB
Weld or slow Epoxy and bond the fittings in place making
sure
one end fitting is turned 90
0
degrees on each strut. Al-
low to dry overnight.
Gas SE only
#HW6202A Carbon Support
Struts x 2 & End Fittings x 4
Step 79 Horizontal Tail Fin
Insert two M3x35 socket cap screws through the horizontal fin and slide the the tail fin mount half ( thicker mount half
with the square ends) against the fin. Position over the tail boom and slide the matching fin mount with the tapered ends
(taller side of the taper toward the mechanics), followed by the aluminum tail support struts and loosely install the two M3
locknuts.
Step 80 Horizontal Tail Fin - Gas SE
#HI6067
Horizontal
Tail Fin
#HI6068 Up-
per Tail Fin
Mount
M3x35
Socket Cap
Screw x 2
#HW6202
Aluminum
Support
Struts x 2
#HI6068
Lower Tail
Fin Mount
M3 Locknut
x 2
Gas SE only
#HI6067A
Carbon Hori-
zontal Tail
Fin
#HI6068 Up-
per Tail Fin
Mount
M3x40
Socket Cap
Screw x 2
#HW6202A
Carbon Sup-
port Struts
x 2
#HI6068
Lower Tail
Fin Mount
M3 Locknut
x 2
Insert two M3x40 socket cap screws through the horizontal fin and slide the the tail fin mount
half ( thicker mount half with the square ends) against the fin. Position over the tail boom and
slide the matching fin mount with the tapered ends (taller side of the taper is towards the me
-
chanics), followed by the carbon tail support struts and loosely install the two M3 locknuts.
