Page 9
For technical questions, please call 1-888-866-5797.
ITEM 69674
Sa
Fety
Setup
Opera
ti
O
n
Maintenance
4.
Full level
Full level
Reinsert the Dipstick without threading it in and
remove it to check the oil level. The oil level
should be up to the full level as shown above.
5. If the oil level is at or below the low mark add the
appropriate type of oil until the oil level is at the
proper level. SAE 10W‑30 oil is recommended
for general use. (The SAE Viscosity Grade
chart on page 15 in the User‑Maintenance
Instructions section shows other viscosities
to use in different average temperatures.)
6. Thread the dipstick back in clockwise.
cautiOn!
Do not run the engine with too little oil.
The engine will be permanently damaged.
checking and Filling Fuel
WarninG!
tO preVent SeriOuS
inJury FrOM Fire:
Fill the fuel tank in a well‑ventilated area
away from ignition sources. If the engine is
hot from use, shut the engine off and wait
for it to cool before adding fuel.
Do not smoke.
1. Clean the Fuel Cap and the area around it.
2. Unscrew and remove the Fuel Cap.
3. If needed, fill the Fuel Tank to about 1 inch under
the fill neck of the Fuel Tank with 87 octane or
higher stabilizer‑treated unleaded gasoline.
note: Do not use gasoline containing more than
10% ethanol (e10). Do not use e85 ethanol.
note: Do not use gasoline that has been stored in a
metal fuel container or a dirty fuel container. it can
cause particles to enter the carburetor, effecting
engine performance and/or causing damage.
4. Then replace the Fuel Cap.
5. Wipe up any spilled fuel and allow excess
to evaporate before starting engine.
To prevent FIRE, do not start the engine
while the smell of fuel hangs in the air.
using the Generator
Before Starting the Generator engine
Before starting the engine:
a.
Follow the Set up instructions
to prepare the Generator.
b.
unplug all loads from the Generator.
c.
inspect the Generator and engine.
d.
Fill the engine with the proper
amount and type of both
stabilizer-treated fuel and oil.
Basic Generator use procedure - See
following pages for specific instructions
1. Check that the generator can handle the
wattage needed to power your products.
2. Start the Engine, and allow the Engine and
Generator to run and warm up for five minutes
after starting with no electrical load.
3. Plug in products.
4. When finished using the Generator,
disconnect all electrical loads.
note:
Do not allow generator to run
out of fuel with loads attached.
5. Turn off the Engine.
allow
the Generator and its Engine to completely cool.
Then store the unit in a clean, dry, safe location out
of reach of children and other unauthorized people.
iMpOrtant:
After starting the engine, allow it to
run at no load for five minutes with no load after
each start‑up so that the engine can stabilize.
6. Break‑in Period:
a. Breaking‑in the engine will help to ensure
proper equipment and engine operation.
b. The operational break‑in period will last
about 3 hours of use. During this period:
• Do not apply a heavy load to the equipment.
c. The maintenance break‑in period will last
about 20 hours of use. After this period:
• Change the engine oil.
Under normal operating conditions
subsequent maintenance follows the schedule
explained in the SERVICE section.
