©2019 Precor Inc. | Seated Leg Curl RSL 619 | Assembly Guide
15
Complete the Assembly
IMPORTANT
As floor materials vary, it is important that you consult a licensed contractor to advise you on proper bolting techniques and appropriate fastener
types.
Standards can be changed or updated. Precor recommends that you keep apprised of your local industry standards. Precor shall not be liable for fail-
ure to properly secure and bolt strength equipment to the floor.
Precor recommends that the strength equipment be bolted down at all anchoring points. Adjust the round feet on the frame up or down by turning them left or right to help level the
equipment.
Anchor each oblong foot on the frame to the floor, including the feet on the weight stack tower. Each oblong foot has a rubber cap with slits to allow access the anchor points.
Final Checklist
•
Lubricate the guide rods and chrome pad adjustment tubes with a Teflon spray lubricant. Precor recommends using TriFlow brand.
•
For all movable arm and pad frames, adjust and test each position. Verify that the adjustment pin fully engages and inserts freely into each position.
•
Verify cables fully sit in cams (if applicable) and in pulleys. Cables should move without rubbing.
•
Place the selector pin into the holder on the top plate assembly of the weight stack. Perform the exercise slowly. Verify cable moves freely without any binding. Select a
moderate weight and repeat.
•
Verify the selector pin can be inserted into each weight plate.
•
Verify all fasteners and the cable retention nut are tight. Ensure they meet the torque call outs in the assembly guide.
•
Refer to the Maintenance Guide that came with your product for details on maintaining the equipment.
