To attach the seat frame:
1.
Place the seat frame on the lower cross tube and secure it using two bolts and
two washers (Figure 2).
2.
Secure the bottom of the frame using two bolts and two washers .
3.
Attach the seat frame to cross bar using one bolt and one washer .
4.
Tighten all bolts in Figure 1 followed by all bolts in Figure 2.
5.
Cover the seat frame bolt with a plug .
Figure 2
To attach the support platform to the crossbar:
1.
Attach the support platform to the crossbar using two bolts and two washers .
2.
Set the support platform on its support frame with the platform lip toward the back facing
downward. Attach it using two bolts , two washers and two nylock nuts .
3.
Attach the foot cover using two screws (Figure 3).
Figure 3
To attach the seat pads:
1.
Using two bolts
and two washers , attach the back pad to the seat frame with the seam end facing
toward the floor (Figure 4).
2.
Cover each frame hole with a plug .
3.
Attach the seat pad to the seat frame using three bolts and three washers .
Figure 4
To attach a short weight storage horn:
1.
Insert the weight horn into the hole in the equipment frame until it stops (Figure 5).
If needed, use a rubber mallet to tap it gently into place.
2.
Secure the weight horn using a bolt and a washer .
3.
Push the storage horn bumper onto the horn with its wide side facing outward.
If needed, use a weight plate to push the bumper against the equipment frame.
4.
Repeat this procedure to attach the other weight horns.
Figure 5
Bolt the equipment to the floor
Precor recommends that the strength equipment be bolted down at all anchoring points. Bolting is made
possible by removing the end caps at the frame base and exposing the mounting holes that accommodate
the bolts (see the accompanying figure). Replace end caps when bolting is complete.
Important
As floor materials vary, it is important that you consult a licensed contractor to advise you on proper
bolting techniques and appropriate fastener types.
Standards occasionally change or are updated. Precor recommends that you keep apprised of your local industry
standards. Precor shall not be held liable for failure to properly bolt the strength equipment to the floor.
Figure 6
Olympic Shoulder Press (507) Assembly Guide | P/N CW39236-101 rev B, ENU
©2016 Precor Incorporated | May 2016
