Assembling the Equipment
7
2.
Attach the base of the lift assembly using two
⁵₁₆
-inch x
³₄
-inch hex head
screws and two
⁵₁₆
-inch flat washers. Partially tighten the fasteners.
Figure 6: Secure base of lift assembly
3.
Tear the foam pouch off the ramp.
4.
Attach the ramp to the yoke using two
³₈
-inch x 2
³₄
-inch buttonhead cap
screws, two
⁵₁₆
-inch washers, and two
³₈
-inch lock nuts. Fully tighten the
fasteners using a
⁷₃₂
-inch hex key and a
⁹₁₆
-inch socket wrench.
Figure 7: Ramp to yoke attachment
5.
Fully tighten the two fasteners at the base of the lift motor assembly using a
¹₂
-inch socket wrench. Do not use the socket wrench extension in this step.
Figure 8: Fastener location at base of lift motor
6.
Cut the tie wrap that secures the lift motor.
7.
Connect the six-pin connector to its receptacle near the lift motor.
Figure 9: Six-pin connection
