Cardio Theater Integrated Bracket Assembly Instructions
page 6
Install the Bracket Assembly
3
Important
: Assemble the fasteners throughout
these instructions as detailed in each step. When
in doubt, use the illustrations for help.
Do not fully
tighten fasteners until instructed to do so.
1.
Remove the bracket cover.
Loosen the bolts on the pivot tube using a
⁷⁄₃₂
-inch hex key. Pull the bracket cover away
from the assembly. Set it aside.
2.
Feed the cables through the center tube of the
bracket assembly.
Locate the coaxial/power cable and controller
cable provided with the LCD Screen. Feed the
end of the coaxial/power cable with its two
connectors and the controller cable through the
top hole in the center tube of the bracket
assembly. Leave about 3 feet of the cables
hanging out of the hole at the top of the bracket.
Note:
The 3 feet (1 meter) of cables hanging out
of the upper hole consist of the controller cable
and the end of the coaxial/power cable with
coaxial and power connectors. These cables will
be attached to the back of the LCD Screen.
Install the Bracket
Assembly
Bracket
cover
Bracket
assembly
Bracket
cover
1
Bracket
assembly
2
Coaxial/power
cable
Controller cable
Bracket assembly
Center
tube
Pivot
tube
