Precor AMT 835, Assembling And Maintaining Manual

Page: 26 / 100

24
Assembling and Maintaining Adaptive Motion Trainers: AMT 885 /835
Replacing Access Covers
After you install the console cables, you can return the access
covers to their previous positions on the equipment.
To replace the access covers:
1. Snap the front cover back into place. Reinsert the two
buttonhead screws you removed with the front cover,
then tighten them using a
⁵₃₂
” hex wrench.
2. Position the top column cover between the handlebars
and the body of the AMT. Make sure that the sides of the
top column cover extend over the upper edges of the
body covers, then use the heel of your hand or a rubber
mallet to tap the cover back into place.
Leveling the AMT
It is important that you level and stabilize the AMT properly
every time you move it.
CAUTION: To eliminate movement, make sure the adjustable feet
are in contact with the floor. Also, make sure that the unit sits on
a flat surface. Adjusting the feet of the unit cannot compensate
for extremely uneven surfaces.
To level the AMT:
1. Gently rock the AMT while standing on one of its foot
plates and grabbing the opposite handlebar. First stand on
the left foot plate and grab the right handlebar to rock the
AMT, then repeat the step while standing on the right
foot plate and holding the left handlebar. If there is any
movement, ask your assistant to tip the unit on its side
while you locate the adjustable feet.